Data quality checks

  • Updated

The importance of accurate data

  • Once data is entered, review it carefully for inconsistencies or anomalies.
  • Accurate, reliable data helps customers rely on the reporting and helps the organization track performance and progress toward its targets.

In-platform checks to ensure data quality

🤖Secaro checks data automatically and shows an alert when a value is outside the typical range.

These checks cover the following data:

  • Energy, emissions, water and waste metrics; and
  • Supplier output per customer (part of the Scope 3 estimator calculation)

For unusually high or low values, a warning message appears, for example This value is higher than expected - please verify. Warnings do not stop a report being shared.

💡A similar warning appears when a data point varies by more than 20% from the last report for that facility or organization. The message is This is a substantial change to the last time you reported this value in [year]. Please check.

  • If this happens, check for errors in the workings or in data entry.
  • Values above or below the accepted limit block sharing, with the message This number is higher than Secaro expects (or lower). If the value is correct, suppliers can contact support to request an exception. Exceptions apply only to facility reports and only to high values.

How to identify anomalies in reports

Anomalous data is not necessarily incorrect, but it should be checked to confirm that no errors have been made.

Methods to identify anomalies include:

  • Significant deviations from a trend, where there is no obvious reason why this would be the case:

    This includes normalized trends, which means comparing the data with production output, or energy use, to make allowance for expected changes.

  • Estimated Scope 3 emissions would not usually contribute more than 99% of a supplier’s total Scope 1, 2 & 3 combined. Similarly, the Scope 3 proportion would not usually be less than the combined Scope 1 & 2 emissions.
  • Non-energy related emissions would not usually amount to more than 25% of the total Scope 1 & 2. These include process emissions from chemical processes, and refrigerants & fugitive emissions.

The Scope 3 proportion and Scope 1 & 2 combustion figures are rules of thumb for manual review. Secaro does not check them automatically.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request